Before Starting the Engine
With the engine running, depress the control rod
lever of the hydraulic unloading valve. The steering
indicator fault light and fault alarm should go ON. The
motor indicator should stay OFF.
With the engine running, move and hold the
supplemental steering switch 1 on the control console
to MANUAL. The motor indicator 2 should go ON. The
machine should steer normally. The steering indicator
fault light 3 should stay off.
With the engine at low idle, the transmission
modulator pedal depressed and the transmission control
in the highest gear, release the transmission modulator
pedal to stall the engine. The steering indicator fault light
3 and the motor indicator 2 should go ON. The machine
should steer normally. Pull the accelerator pedal up to
the engine shut- off position. The motor indicator 2
should go OFF, the steering indicator 3 and fault light
should stay ON.
Replace the seat belt or mounting hardware if they are
damaged or Worn. Replace the belt at least every three
Adjust and fasten the seat belt before
operating the machine.
Inspect for worn or frayed webbing. Check for worn or
damaged buckle or anticreep slide, on each half of the
belt. Replace the belt, buckle or slides if they are worn or
Inspect the belt mounting hardware. Replace any worn
or damaged hardware.