Disconnect the articulation angle indicator cable
from the left side of the machine. Relocate the
various lines to the left side of the rear frame
behind the platform brace.
Remove the outer circle of six (6) retaining bolts
from the top of the lower pin.
Connect the auxiliary pump supply and return
lines to the jumper hoses. Connect the jumper
hoses to the appropriate connectors on the quick
connector banks. Use the identification tags to
connect the jumpers.
Connect the electrical jumper between the
engine firewall and lower platform connectors.
Install the screw jacks on the back of the rear
frame, one on each side. Adjust the jacks as
needed to remove the load on the pins.
Remove articulation cylinder pins on each side of
the machine by driving down with a drift punch.