REMOVE CENTERSHIFT LOCK
Lower the blade to the ground. Release the air
pressure in the air tank by loosening the bleed
Do not disconnect the air lines from the center-shift
lock until the air pressure is zero.
Put identification on the air lines as to their location.
Disconnect air lines (3) from the centershift lock.
Remove bolts (2) that hold the housing. Remove
housing (1) and the spring. Remove the washers
from inside the housing.
Hit the pin with a hammer to loosen it from lock bar
Remove the pin and the housing from blade lift bar
(8). Remove the O-ring seal from housing (7).
Remove two seals (6) from the piston. Remove the
bolts, the lock and cap (5) from the piston.
Remove the piston from the pin. Remove the O-ring
seal from the pin.
Remove seals (9) from the housing.