TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-16.
Oil Pump and Lines. (Sheet 4 of 6)
INSTALLATION
1.
Position tube assembly (23, Figure 3-73) to oil
pan plate.
2.
Install lock (22) and bolt (21) Bend lock (22)
tab up against bolt (21) head.
3.
Install new preformed packing (20) on tube
assembly (23). Lubricate outer diameter of
new preformed packing (20). With clean oil.
4.
Install elbow (19) on tube assembly (23).
5.
Install items 23 thru 20 as an assembly (Figure
3-72) on oil pan plate.
6.
Install oil pan plate. Refer to paragraph 3-15.
7.
Install key (17) in shaft of oil pump (18).
8.
Install gear (16) on shaft.
9.
Install washer (15) and bolt (14). Tighten bolt
(14) to 32 ft-lb torque.
10. Using suitable driver and press, install new
bearing (13), if removed, flush with outer face
of gear (12).
11. Install gear (12). Aline mark on gear (12) with
gear (16) mark.
12. Lubricate oil pump (18) with clean oil.
Figure 3-73.
Figure 3-72.
Go to Sheet 5
3-94