Frame Separation and Connection. (Sheet 7 of 12)
Remove spacer (51, Figure 16-14).
Separation of frames is not
possible until spacer has
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends and plug all
open hydraulic ports to
Disconnect hose (52, Figure
16-15) and apply shop air supply
line to elbow on parking brake
Release parking brake by applying
air pressure to parking brake
Separate rear frame (53) from
front frame (54) by moving rear
frame (53, Figure 16-16) rearward
Install jack stands under
radiator end of rear frame and
Remove shop air supply line.
Clean all parts. Refer to Chapter 2.
Inspect all parts. Refer to Chapter 2.
Go to Sheet 8