FINAL DRIVE ASSEMBLY REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
Install two 3/4-10NC forcing screws in housing (19).
Tighten each forcing screw a small amount at a time,
alternating between screws, until housing has been
moved far enough out on the studs to install a link
bracket sling on housing. Put axleshaft (18) in position
in housing to keep planet carrier assembly (17) in bal-
ance. Use link bracket sling to carefully remove planet
carrier assembly from machine.
Install wire from forcing screws behind housing
assembly (19) across planet carrier assembly (17) to
keep inner components from falling.
Position housing (23) on blocks with planet carrier
(22) facing up. Remove wire and forcing screws from
Remove preformed packing (20) and gear (21). Dis-
card preformed packing.