FINAL DRIVE ASSEMBLY REPLACEMENT - CONTINUED
The following procedure covers replacement of left final drive. Follow these procedures for right final drive.
Remove preformed packing (2) and roller bearing (1). Discard preformed packing.
Tie shim(s) together and tag for identification.
Remove 16 bolts (7), washers (6), retainer (5), shim(s) (4), and thrust washer (3). Discard thrust washer.
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
Tandem housing weighs 2,300 lb (1,043 kg).