ROCKER ARM ASSEMBLY MAINTENANCE - CONTINUED
The following step is for locating number one cylinder Top Center (TC).
Remove starting motor (59) on right side of engine (WP 0067 00).
Install engine turning gear on starting motor mounting flange.
In the following steps, the engine is viewed from the flywheel end.
Turn engine clockwise 30 degrees, using engine turn-
ing gear to remove timing gear play.
Remove plug (60).
Turn engine counterclockwise, using engine turning
gear and ratchet. Look through hole where plug (60)
was removed for threaded hole in flywheel where 3/8-
16NC bolt can be installed. If hole is passed, repeat