FLYWHEEL AND FLYWHEEL HOUSING REPLACEMENT - CONTINUED
Remove plugs (1 and 4) from rear of engine.
Using scriber, matchmark flywheel assembly (2) and crankshaft at same location.
Install two link brackets and 3/8-16-2B bolt on flywheel assembly (2).
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
Flywheel assembly weighs 120 lb (54 kg).
Attach sling to link brackets.
Install 5/8-18NF guide bolts.
Remove seven screws (3).
Remove two screws (3).
Use sling to remove flywheel assembly (2).
Remove sling and link bracket.