CIRCLE DRIVE MOTOR ASSEMBLY REPLACEMENT - CONTINUED
Hose ports of circle drive motor face outside left.
Install circle drive motor (3), four washers (1), and bolts (2).
Later configuration machines have four seals instead of two O-rings.
Install two new O-rings (5).
Install two connectors (4).
Connect two hose assemblies (6) to connectors (4) on circle drive motor (3).
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
Start engine (TM 5-3805-261-10).
Operate circle drive control lever. Move system through at least five full movements of travel to bleed air from system
Inspect hose assemblies and connections. Check for leaks.
END OF WORK PACKAGE