TRANSMISSION MODULATION CONTROL MAINTENANCE - CONTINUED
ADJUSTMENT - CONTINUED
Adjustment must be made with engine running. Keep all personnel away from machine. Allow only operator
on machine. Make sure parking brake is applied. Failure to follow this procedure may cause injury.
Turn battery disconnect switch to ON position and
start engine (TM 5-3805-261-10).
Fully depress pedal (3) and hold down until step 5 is
Pull lever (13) backward to OFF position to release
Move lever (12) backward to first speed.
Release pedal (3) slowly until wheels start to turn,
then depress until wheels stop. Hold pedal in this posi-
Move lever (12) forward to NEUTRAL position.
Turn bolt (11) to left until head of bolt contacts pedal (3). Back off one complete turn.
Tighten nut (10) to secure bolt (11).
Depress pedal (3) until contact is made with bolt (11). Hold pedal down.
Move lever (12) to all forward and reverse speeds. If wheels do not turn, go to step 12. If wheels turn, repeat steps 5
through 10 until proper adjustment is achieved.
Release pedal (3).
END OF WORK PACKAGE