ELECTRICAL SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
TEST OR INSPECTION
Perform voltage drop test on starting
Solenoid and Starting Motor
Operate; Engine Cranks
Slowly - Continued.
a. Connect meter negative lead to
positive terminal on starting motor
and meter positive lead to MTR
terminal on solenoid.
b. Crank engine and observe meter.
If voltage reading exceeds 0.1 volt, place
battery disconnect switch in OFF position
and clean and tighten starting motor-to-
solenoid connections. Replace if broken.
If the problem still exists, go to Test 5.
Perform voltage drop test on solenoid
a. Connect meter positive lead to
negative lead to solenoid MTR