HYDRAULIC SYSTEM MAINTENANCE. (cont)
Circle Drive Motor Assembly. (Sheet 3 of 3)
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
Start engine. Refer to TM 5-3805-261-10.
Operate circle drive control lever. Move
system through at least five full movements
of travel to bleed air from system. Refer to
Inspect hose assemblies and connections,
Check for leaks.
Refill hydraulic tank in rear left side of
operators compartment to proper level.
Refer to LO 5-3805-261-12.
End of Task