WIRING HARNESS MAINTENANCE. (cont)
General Repair. (Sheet 13 of 15)
Multi-wire connector, hard shell. (cont)
Strip wires, refer to chart (Figure 7-191). Do
not cut or nick wire strands.
Tin bare wires. Use resin-core solder to
coat bare wires. If using solid core solder,
clean wires with flux before tinning.
Slide new shell (Figure 7-198) onto wire.
Insert wires into connector pins or socket
wells as indicated on tags.
Crimp wires securely to fasten wires to
Solder wires. Secure wires and terminal to
prevent movement. Use solder sparingly.
Insert terminal assembly into shell.
Tighten two screws.
Go to Sheet 14