SENDING UNITS AND WARNING SWITCHES MAINTENANCE. (cont)
Coolant Temperature Switch. (Sheet 2 of 3)
Remove pressure from system by
slowly removing radiator cap. Allow
performing this procedure.
Remove two screws (1) and lockwashers
(2, Figure 7-142).
assemblies must be tagged before
disconnecting to aid in installation.
Disconnect two wire assemblies (3) at
terminals from switch (4) on top of water
pump (5) on front, left side of engine.
Remove switch (4).
Clean all parts. Refer to Chapter 2.
Inspect all parts. Refer to Chapter 2.
Go to Sheet 3