OPERATORS PANEL CONSOLE TROUBLESHOOTING AND MAINTENANCE PROCEDURES. (cont)
TEST OR INSPECTION
START SWITCH DOES NOT OPERATE.
Step 1. Test the continuity of the start switch. Connect one lead of multimeter to switch and one lead to ground.
If the multimeter needle does not move, the circuit does not have continuity. Replace start switch. Refer to
Step 2. Test the continuity of the wire assemblies. Connect multimeter to each end of wire assembly.
If the multimeter needle does not move, the circuit does not have continuity. Replace wire assembly. Refer to
paragraphs 7-34 and 7-117.
Step 3. Repeat step 2 for remaining wire assemblies.