TM 5-3805-261-20
FUEL SYSTEM MAINTENANCE. (cont)
6-28.
Ether Starting Aid Assembly. (Sheet 3 of 4)
REMOVAL (cont)
NOTE
All hose and tube assemblies must be
tagged before disconnecting to aid in
installation. Cap all hose and tube
ends to prevent contamination.
9.
Disconnect tube assembly (20, Figure 6-80)
from rear, left of engine compartment.
10.
Remove tube (19).
11.
Disconnect tube assembly (20) from tube
(24) and remove.
12.
Remove bolt (21), washer (22) and clip (23,
Figure 6-81) from base of turbocharger air
pipe on left side, top of engine.
13.
Disconnect tube (24) from atomizer (25)
and remove.
14.
Remove atomizer (25) from cylinder head.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install atomizer (25, Figure 6-81) in cylinder
head.
2.
Connect tube (24) to atomizer (25).
Figure 6-80.
Figure 6-81.
Go to sheet 4
6-106