FUEL SYSTEM TROUBLESHOOTING AND MAINTENANCE PROCEDURES. (cont.)
TEST OR INSPECTION
Step 1. Inspect connections on accelerator in the cab. Refer to Chapter 2.
Step 2. Inspect connections on fuel injection pump (Figure 6-29).
Tighten connections on fuel injection pump. Refer to paragraph 6-15.
Step 3. Check to see that governor cable is intact.
If governor cable is not intact--contact Direct Support (Figure 6-29).
Step 4. Inspect cables and connectors. Refer to Chapter 2.
Replace defective cables or connectors. Refer to paragraph 7-116.
Step 5. Contact Direct Support.