Section III. SCARIFIER ASSEMBLY TROUBLESHOOTING.
GENERAL INFORMATION. This section lists the common scarifier assembly malfunctions which may occur
during the operation of the 130G Grader. You should perform the tests, inspections and corrective actions in the order
listed. Follow the troubleshooting procedures listed below step-by-step until you can go no further.
SCARIFIER ASSEMBLY TROUBLESHOOTING PROCEDURES. This section cannot list all possible
malfunctions, nor can-it list all possible tests, inspections or corrective actions. If a malfunction is not listed, contact your
SCARIFIER ASSEMBLY TROUBLESHOOTING AND MAINTENANCE PROCEDURES.
TEST OR INSPECTION
SCARIFIER SHANKS ARE BROKEN OR MISSING.
Check to see if the scarifier shanks (1) and teeth (2, Figure 17-32) are missing or broken.
If the scarifier shanks or teeth are damaged or defective--replace. Refer to paragraph 17-12.