GAGES AND INDICATORS (NON-ELECTRICAL) MAINTENANCE. (cont)
Air Pressure Gages. (Sheet 2 of 3)
All hose and tube assemblies must
be tagged before disconnecting to
aid in installation. Cap all hose and
tube ends to prevent contamination.
Disconnect two hose assemblies (1, Figure
16-4) from instrument panel, right side of
Remove two elbows (2).
Remove four nuts (3), lockwashers (4) and
two brackets (5).
Remove two air pressure gages (6) and
seals (7, Figure 16-5) from outside of
vehicle, right side of engine compartment.
Clean all parts. Refer to Chapter 2.
Inspect all parts. Refer to Chapter 2.
Go to Sheet 3