HYDRAULIC SYSTEM MAINTENANCE. (cont)
Blade Lift Lines, Fittings and Hoses. (Sheet 10 of 10)
Connect two hose assemblies (8,Figure 15-
79) to right control valve group.
Connect two hose assemblies. Refer to
paragraph 15-33, steps
11 and 10.
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
Start engine. Refer to TM 5-3805-261-10.
Operate left and right blade lift controls.
Move system through at least five full
movements of travel to bleed air from
Inspect hose assemblies and connections
Refill hydraulic tank to proper level. Refer
to LO 5-3805-261-12.
End of Task